第 38 卷第 3 期 |  | Vol. 38 No. 3 | 2008 年 6 月 | Jun 2008 |
|
所屬欄目:農藥及中間體
鄰甲代烯丙氧基苯酚合成呋喃酚工藝研究 |
孔祥云1,蔣 彪1,2,羅和安1
(1. 湘潭大學 化工學院,湖南 湘潭 411105;2. 湖南化工研究院 國家農藥創(chuàng )制工程技術研究中心,湖南 長沙 410007) |
摘 要:以鄰甲代烯丙氧基苯酚為原料,異丙醇鋁為催化劑,在溶劑二甲苯的條件下,經過Claisen重排和環合反應合成呋喃酚。重點研究了物料配比、反應溶劑、反應溫度、反應時間對反應的影響,優化條件為:鄰甲代烯丙氧基苯酚濃度為32%(m / m),異丙醇鋁3.0%(m / m),反應溫度高于150℃,反應時間10 h。此條件下反應的轉化率可以達到96%以上,選擇性78%,收率75%。 |
關鍵詞:鄰甲代烯丙氧基苯酚;呋喃酚;環合反應;工藝研究 |
中圖分類號:TQ251.1 文獻標識碼:A 文章編號:1009-9212(2008)03- 0015-03 |
|
Synthesis of Benzofuranol from Methallyloxyphenol |
KONG Xiang-yun1,JIANG Biao1,2,LUO He-an1
(1. School of Chemical Engineering,Xiangtan University,Xiangtan 411105,China;2. National Engineering Research Centre for Agrochemicals,Hunan Research Institute of Chemical Industry,Changsha 410007,China) |
Abstract:In the preparation of benzofuranol from methallyloxyphenol through Claisen- rearrangement and cyclization, aluminium isopropoxide was used as catalyst,xylene was used as solvent. The material ratio,solvent,reaction temperature and reaction time were studied. The optimum reaction conditions were determined as follows:n(methallyl- oxyphenol) ∶ n(xylene)=1 ∶ 3,the mass fraction of aluminium isopropoxide is 3.0%,the temperature was higher than 150℃,the reaction time was 10 h. Under these operation conditions,the conversion was over 96%,selectivity was 78%,the yield of benzofuranol was 75%. |
Key words:methallyloxyphenol ;benzofuranol;cyclization;optimization |
|
基金項目:湖南省自然科學基金資助項目(05JJ30025)。
|
作者簡介:孔祥云(1981-),男,湖南長沙人,碩士研究生,主要從事化學工程與工藝研究。
|
聯 系 人:羅和安,教授。(E-mail:hluo@xtu.edu.cn)
|
收稿日期: 2008-06-0
|
|