| 第 35 卷第 4 期 |  | Vol. 35 No. 4 | | 2005 年 8 月 | Aug 2005 |
|
所屬欄目：功能材料
SEBS接枝MAH改性PA6物理性能研究 |
| 葉強; 張愛民; 周燎原(巴陵石油化工有限責任公司合成橡膠事業部; 四川大學國家高分子材料與工程重點實驗室; 湖南岳陽; 四川成都) |
| 摘 要：研究了PA6/SEBS和PA6/SEBS-g-MAH共混體系與PA6/SEBS/SEBS-g-MAH三元共混體系的力學性能與流變性能變化。結果表明,采用SEBS增韌尼龍6,控制SEBS和SEBS-g-MAH的比例,在SEBS總量為20%時能夠制得超韌性的尼龍6,缺口沖擊強度可達到90kJ/m2以上。PA6/SEBS表現出不相容共混體系的流變行為,PA6/SEBS-g-MAH共混體系高于共混物中任一組分的粘度,反映出共混后增強了兩相的界面相互作用。三元共混體系的粘度表現為SEBS和SEBS-g-MAH共同作用結果。 |
| 關鍵詞：SEBS; 改性; MAH; 物理性能 |
| 中圖分類號：TQ330.7 文獻標識碼：A 文章編號：1009-9212(2005)04-0063-04 |
|
| Study on the Physical Properties of SEBS-g-MAH Modifying PA6 |
| YE qiang1; ZHANG Ai-ming2; ZHOU Liao-yuan1 （1. Synthetic Rubber Plant Baling Petrochemical CO.; Ltd; Yueyang 414014; China; （2. Research institute of Polymer materials and Engineering Sichuan university; Chendu 610065; China） |
| Abstract：Mechanical and rheological properties have been investigated of PA6/SEBS blends ,PA6/SEBS-g-MAH blends and PA6/SEBS/SEBS-g-MAH blends in this paper. The results showed that touchening PA6 is available and the impact strength was above 90 KJ/m2 when the total amount of SEBS is 20% adopting SEBS modifying PA6.PA6/SEBS blends act as imcompatibility rheology ,PA6/SEBS-g-MAH have the highest viscosity among the blends,the action of interphase is strengthened after blending.Viscosity of PA6/SEBS/SEBS-g-MAH is the... |
| Key words：SEBS; modification; MAH; physical properties |
|
基金項目：國家“863”資助項目(No2003AA333020)
|
收稿日期：2005-04-08
|
| 閱讀全文 |
|